To achieve specified surface finish and dimensional requirements, we utilize chemically bonded and resin shell sand, as well as the REPLICAST™ process for producing a variety of stainless steel and special alloy casting.

Stainless Steel positive displacement pump body, cover and gear case cast in CF8M(316 SS) (Mold process chemically bonded sand)

 

High pressure housing for land-based turbine fuel delivery system (cast in CB7cu(17-4) 80lbs. Distributor casting for sea water/fuel separator aboard Navy vessel cast in CF8M (316 SS) 115lbs.

Air inlet duct for locomotive engine turbo charger cast in HK-30 using the ReplicastTM process. Chamber wall thickness is .180". Casting weight - 180 lbs. Pintle Journal for military vehicle transmission cast in austempered ductile iron (23lbs.)(Replicast)

Turbo charger housings for piston driven aircraft engines cast in HK30 (Shellmold Process)